The method of cycle-slip detection and repair GNSS meaturements by using receiver with high stability frequency oscillator

Authors

  • Nikolai S. KOSAREV Siberian State University of Geosystems and Technologies, Novosibirsk, Russia
  • Konstantin M. ANTONOVICH Siberian State University of Geosystems and Technologies, Novosibirsk, Russia
  • Leonid A. LIPATNIKOV Siberian State University of Geosystems and Technologies, Novosibirsk, Russia

DOI:

https://doi.org/10.2478/congeo-2019-0015

Keywords:

GNSS, receiver, measurement, carrier phase, cycle slip, moving average, geometric range

Abstract

A method of phase GNSS measurement control is described. The method is based on comparison of geometric range increments which are calculated using measurement data and approximate receiver coordinates and satellite navigation message position taking into account troposphere and ionosphere correction increments. Applicability of moving average for phase GNSS measurement control to detect the cycle slips and outliers is demonstrated. Test results of cycle slip detecting in phase measurements made by the receiver with high stability frequency oscillator are provided.

Author Biographies

Nikolai S. KOSAREV, Siberian State University of Geosystems and Technologies, Novosibirsk, Russia

10 Plakhotnogo St., Novosibirsk, 630108 Russia

Konstantin M. ANTONOVICH, Siberian State University of Geosystems and Technologies, Novosibirsk, Russia

10 Plakhotnogo St., Novosibirsk, 630108 Russia

Leonid A. LIPATNIKOV, Siberian State University of Geosystems and Technologies, Novosibirsk, Russia

10 Plakhotnogo St., Novosibirsk, 630108 Russia

Downloads

Published

2019-09-30

Issue

Vol. 49 No. 3 (2019)

Section

original research papers