New Measurement Method of Oil-Water Two-Phase Flow with High Water Holdup and Low Rate by Phase State Regulation

Authors

  • Lianfu Han School of Electrical and Automation Engineering, Changshu Institute of Technology, South Third Ring Road, No.99, 215500, Suzhou, China; School of Physics and Electronics Engineering, Northeast Petroleum University, Xuefu Street Road, No99, 163318, Daqing, China
  • Ming Chen School of Physics and Electronics Engineering, Northeast Petroleum University, Xuefu Street Road, No99, 163318, Daqing, China
  • Xingbin Liu School of Physics and Electronics Engineering, Northeast Petroleum University, Xuefu Street Road, No99, 163318, Daqing, China
  • Changfeng Fu School of Electronic and Information Engineering, Changshu Institute of Technology, South Third Ring Road, No.99, 215500, Suzhou, China https://orcid.org/0000-0003-1799-8500

DOI:

https://doi.org/10.2478/msr-2023-0034

Keywords:

Oil–Water Two-Phase Flow, Phase State Regulation, Flow Rate, Holdup

Abstract

Flow rate and holdup are two essential parameters to describe oil-water two-phase flow. The distribution of oil-water two-phase flow in the pipeline is very uneven, and there is a significant slippage between the phases. This makes it difficult to measure these two flow parameters. In this paper, a new measurement method of flow rate and holdup based on phase state regulation is proposed. The oil-water two-phase flow is adjusted to oil or water single-phase flow according to the time sequence by the phase state regulation, and the oil-water phase interface is measured with a conductance sensor. A wavelet transform based phase inflection point detection model is proposed to detect the oil-water phase change point. The experimental results show that the maximum measurement error of the flow rate of water is 3.73%, the maximum measurement error of the flow rate of oil is 3.68%, and the flow rate measurement repeatability is 0.0002. The accuracy of the measurement holdup is better than 3.23%, and the repeatability of the measurement holdup is 0.0003. The prototype designed based on this method has two advantages. One is that it is small in size, the other is that it does not depend on the accuracy of the sensor. Therefore, it can be widely used in oilfield ground measurement.

Downloads

Published

17.11.2023

How to Cite

Han, L., Chen, M., Liu, X., & Fu, C. (2023). New Measurement Method of Oil-Water Two-Phase Flow with High Water Holdup and Low Rate by Phase State Regulation. Measurement Science Review, 23(6), 268–274. https://doi.org/10.2478/msr-2023-0034

Similar Articles

<< < 1 2 3 

You may also start an advanced similarity search for this article.